Vacuum Modulation Routing Controls

The Modulation Routing section gives you the ability to go beyond the default modulation routings, and get deeper into designing sounds.

There are two modulation paths, each with three controls.

 

Modulation Routing controls

Source

Sets what signal is used to modulate the chosen parameter. The choices are:

 

Source	Description
Env 1	Envelope 1 modulation signal
Env 2	Envelope 2modulation signal
VTO 1	Oscillator 1 signal
VTO 2	Oscillator 2 signal
LFO	The LFO controlled in the Pitch and Mod Wheel section’s signal
LFO X MW	The LFO controlled in the Pitch and Mod Wheel section’s signal, attenuated by the Mod wheel
MW	The position of the Mod wheel
AT	The amount of Aftertouch, if supported by your MIDI controller

Destination

Sets which parameter is modulated. The choices are:

 

Destination	Description
Pitch	Pitch of both oscillators
VTO 1 Wave	Oscillator 2wave shape
VTO 2 Pitch	Oscillator 2 pitch parameter
VT HPF	High pass filter cutoff frequency
VT LPF	Low pass filter cutoff frequency

Depth

Sets the amount of modulation that occurs. At its center, no modulation will occur. To the right, modulation increases, and to the left, modulation also increases, but with reversed polarity.